Coincident noncoincident peaks report

This report is designed for use by C&I implementations. The report provides interval-by-interval demand, consumption, and pulse data for each contributor to an aggregated channel.

Scalability

This report is designed to function as a spot report for a single service point.

Use the following procedure to configure a task template:

  1. Go to System Operations > Task Management > Task Templates.

  2. Use the dropdown menu to select the Task Type and Task Template. (Click Add to create a new task template. For more information, see Adding task templates.)

  3. Configure the Task specific parameters. These parameters are defined after step 5 of this procedure.

  4. Configure the Common task template parameters. For more information, see Task template parameters.

  5. Click Save.

Task specific parameters:

Select Report Options

ClosedInterval Size

Defines the interval size (in minutes) to use for the task output. For example, if you are running a report on 15-minute interval data and you set the task template interval size to 60, the task aggregates the 15-minute intervals and displays the results as 60-minute intervals.

ClosedRoll

Defines the length of time over which to average the demand, and allows you to smooth demand. Rolling demand may be required for billing purposes. For example, if the export is for billing, and the customer contract specifies billing on a 60 minute rolling demand for data that is metered in 15 minute intervals, set the Rolling Interval Length to 60. When you export the data, there is an interval value every 15 minutes. However, the value is an averaged demand value over 60 minutes that ends at the timestamp for each 15 minute interval. In this case, the averaged intervals are the current interval plus the three previous intervals.

ClosedAs Metered

Defines the data that is graphed. Select this check box to override the Output Interval and Minutes to Roll options and graph the data as metered. It uses the configuration of the service point for graphing. The As Metered default is controlled by the Default Output Interval Is As Metered workgroup setting.

ClosedApply Losses

Determines if IEE will apply losses when calculating values for the report. Select this check box to enable this parameter.

ClosedShow Losses

Determines whether losses display in the report. Select the check box to display the losses.