Intelis Gas Meter in Mobile Mode Check Endpoint Response Fields

The ERT module’s device identification number.

The index with a correction applied.

The index without a correction applied.

Identifies the billing index that has intervals.

The volume of usage that occurred under an alarm.

The module’s endpoint model (OWR Intelis Gas).

The meter's current programmed meter configuration (Intelis Gas Meter). The field name is a hyperlink that opens the meter configuration log, where you can view details about the meter configuration. See Programmed Meter Configuration Response Fields.

The selected unit for display.

The pressure compensation value programmed into the endpoint to compensate for the effect of atmospheric pressure on recorded consumption.

The time interval, in seconds, at which the endpoint transmits data upstream.

The power level in dBm units at which the endpoint transmits. This value corresponds to the communication mode the module is configured for (+10 dBm or +24 dBm).

The utility ID number assigned to your utility by Itron. This is a unique security code ranging from 0 to 32767 that prevents another utility from performing certain functions on an ERT module. If you enter a number greater than 32767, an error displays and you cannot save the utility ID.

The number of hours/min/sec that the endpoint time has drifted from the network time.

The endpoint’s lock level.

The ERT module’s ChoiceConnect security level.

The number of Tamper events recorded by the meter. The field name is a hyperlink that opens a list of the meter's tampers. See Intelis Gas Meter Events for descriptions of the tampers.

The amount of battery energy, in micro-amp-seconds, that has been used since the device was manufactured.

The amount of time, in milliseconds, that is required for the mechanical contact on the tilt switch to settle before a signal from the switch is considered to be valid by the ERT module. This parameter is used to adjust the sensitivity of the meter removal tamper indicator.

The standard consumption message packet type the ERT module is configured to transmit.

How often flow is sampled for a high flow event.

The rolling window over which a high flow event is determined.

The threshold at which a high flow event is created. Automatic shutoff will occur if it is enabled.

The threshold at which a high temperature event is created. Automatic shutoff will occur if it is enabled.

Whether the device is programmed to shut off automatically in response to a high flow event.

Whether the device is programmed to shut off automatically in response to a high temperature event.

The amount of time, in hours, that the test mode can run. The default test mode run time is one hour.

The pulse width of test mode.

The field name is a hyperlink that opens another screen where you can view details about the meter's firmware versions. See Firmware Versions Response Fields.