Density code table

This code table defines values for the density of the area covered by a route. Creating density codes allows you to select density values such as high, medium, or low to describe the route. Add blank rows to the table and use the input fields to enter the ID and Description for each density level required.

A route or route element is a collection of service points that is read by mobile, handheld or fixed network collection systems on a specific schedule.

Use the following procedure to configure the Density Code Table:

1. Go to System Administration > System Admin > Code Table Setup.

2. From the Code Table Selection list, select Density Code Table.

3. Use the Number of rows to insert on add dropdown menu to select the number of blank rows to add to the code table.

4. From the Code Table Setup menu, click Add. The new rows appear in the table.

5. Click to select each blank row added and configure the following parameters:

   • ID

   • Description

6. Click Enter to save the values to the code table.

7. Click Save.

Note: After updating any code table, you must restart the IIS service for the changes to take effect.