Tampers and Events by Gas Endpoint

The following table lists tampers/events associated with each gas endpoint type:

Endpoint	ERT type	Associated tampers/events
25G - 1 foot	0	Magnetic Tilt
25G - 2 foot	1	Magnetic Tilt
40G/40GB	2	Magnetic Tilt
40G Remote	2	Cable Cut Cable Cut/Magnetic Tilt
40G Rotary (remote)	2	Cable Cut (US models) Cable Cut/Magnetic (Canadian models) Tilt
100G	12	Magnetic Tilt
100G Remote	12	Cable Cut Cable Cut/Magnetic Tilt
Intelis Gas meter		Register Error Magnetic Detected Low Battery Reverse Flow Detected Reverse Flow End Valve OK Valve No Comms Extended High Flow Detected Extended High Flow End High Temperature Detected High Temperature End Air In Pipe Detected Air In Pipe End Critical Error (Internal) Right Sizing Started Right Sizing Completed Right Sizing Canceled Flash Error Meter Quiet Mode Exist Entering OW Riva Network Mode Set Battery Params Set Meter Right Sizing Params Key Update Device Not Communicating Load Profile Cleared Manual Time Sync Legally Relevant Event Log Nearly Full Time Sync - Over Threshold Detected Time Sync - Over Threshold End Entering 100S Mode Entering Prover Mode Exiting Prover Mode Flow While Disconnected Detected Button Press/LCD On Flow Sensor Hard Failure Flow Measurement Outside Physical Range Detected Flow Measured Outside Physical Range End Gas Temperature Outside Sensor Range Detected Gas Temperature Outside Sensor Range End Flow Sensor Measurement Error Transducer Error Device Reconfigured Event Log Cleared Configuration Downloaded System Reboot System Restart Improper Installation Detected Disconnect Completed Disconnect Failed Arm Completed Arm Failed Connect Completed Connect Failed Authentication Failed Access Control Failed Key Rollover Key Signing Takeover Package Accepted Takeover Package Rejected Replay Attack Detected RMA Signed Authorization Received Valve Life Nearing Maximum Auto-disconnect Initiated Prover Mode Maximum Time Configuration Changed High Flow Sampling Configuration Changed High Temperature Configuration Changed High Flow Disconnect Enable Changed High Temperature Disconnect Enable Changed Air In Pipe Disconnect Enable Changed Prover Mode Pulse Width Configuration Changed Prover Mode Pulse Weight Configuration Changed PCOP Changed Count Rate Changed Rollover Count Changed Initial Index Image Transfer Initiated (Enabled) Image Transfer Canceled (Disabled) Image Transfer Cancel Failed Image Verification Initiated Image Verification Successful Image Verification Failed Image Activation Initiated Image Activation Successful Image Activation Failed Load Profile Interval Changed Meter Calibrated
OpenWay Riva 500G Module		Tilt Magnetic Low Battery Tilt Debounce Parameter Changed Cable Cut Cut Cable End Critical Error Flash Error Meter Quiet Mode Exit Entering OW Riva Network Mode Set Battery Params High Flow Threshold Key Update Device Not Communicating Load Profile Cleared Manual Time Sync Time Sync Entering Mobile Mode Device Reconfigured Configuration Downloaded System Reboot Restart Improper Installation Detected Authentication Failed Access Control Failed Key Signing Takeover Package Accepted Takeover Package Rejected Replay Attack Detected PCOMP Changed Count Rate Changed Rollover Count Changed Initial Index Image Transfer Initiated Image Transfer Canceled Image Transfer Cancel Failed Image Verification Initiated Image Verification Successful Image Verification Failed Image Activation Initiated Image Activation Successful Image Activation Failed Legally Relevant Event Log Nearly Full
OpenWay Riva Gas Remote Disconnect (OWR-GRD)		Tilt Valve Tamper Electronic Tamper
OpenWay Riva Gas Gate Remote Disconnect (OWR-GGRD)		Cable Cut Auto Shut Off