100G DLS and 100G ICS Read Endpoint Response Fields

The endpoint’s device identification number.

The meter reading as reported by the endpoint.

Note: A No Read result is returned from an Endpoint reading if a cut cable tamper is discovered.

The endpoint model (100G).

The ERT module’s tilt tamper value, which increments whenever the endpoint has been inverted, vibrated, removed, or tilted 45 or more degrees from its correct installation position. This value does not automatically reset when the module is programmed.

The ERT module’s magnetic tamper value, which increments whenever the module is exposed to a strong external magnetic field. Exposure to a magnetic field can result in under-reported consumption or even cause the ERT module to stop counting. This value does not automatically reset when the module is programmed.

Note: On 100G remote-mount ERT modules, the cut cable tamper replaces the magnetic tamper.

The ERT module’s cut cable tamper value, which increments whenever the module’s cable has been cut or disconnected or has a faulty connection.

The number of times the module received a programming command that affected its metrology.

The number of times the module received a non-metrology programming command.