Tampers and Events by Water Endpoint

The following table lists tampers/events associated with each water endpoint type:

Endpoint

ERT type

Associated tampers/events

40W/50W Pulser

Remote (3-wire)

3

  • Cable Cut
  • Counter value increases by 1 when an event occurs and then latches. Latch state is cleared when ERT is read.
  • Tilt

40W/50W Pulser

Remote (2-wire)

3

  • Cable Cut
  • Not supported and should be ignored if changes are seen.
  • Tilt

40W/50W Pulser

Direct Mount (3-wire)

3

  • Cable Cut
  • Cable is not accessible: however, function is the same as the Remote (3-wire).
  • Tilt

40W/50W Encoder

Remote (3-wire)

3

  • Cable Cut
  • Counter value increases by 1 when an event occurs.
  • Tilt

40W/50W Encoder

Remote (2-wire)

3

  • Cable Cut

    Not supported and should be ignored if changes are seen.

  • Tilt

40W/50W Encoder

Direct Mount (3-wire)

3

  • Cable Cut

    Cable is not accessible: however, function the same as the Remote (3-wire).

  • Tilt

60W/60WP/80W-i

13

  • Leak Detection/Reverse Flow
  • Cable Cut

100W/100WP

11

  • Cable Cut
  • Reverse Flow

OpenWay Riva 500W ERT Module

 

  • Inter Digit
  • Register Error
  • Invalid Read
  • Low Battery
  • Consumer Leak Detected
  • Consumer Leak End
  • Reverse Flow Detected
  • Reverse Flow End
  • Pulse Mismatch
  • Cut Cable Detected
  • Cut Cable End
  • Critical Error
  • Flash Error
  • Meter Quiet Mode Exit
  • Entering OW Riva Network Mode
  • Set Battery Params
  • Key Update
  • Device Not Communicating
  • Load Profile Cleared
  • Manual Time Sync
  • Time Sync
  • Entering Mobile Mode
  • Device Reconfigured
  • Configuration Downloaded
  • System Reboot
  • Restart
  • Improper Installation Detected
  • Authentication Failed
  • Access Control Failed
  • Key Signing
  • Takeover Package Accepted
  • Takeover Package Rejected
  • Temperature Alarm
  • Replay Attack Detected
  • PCOMP Changed
  • Count Rate Changed
  • Rollover Count Changed
  • Count Sample Debounce Changed
  • Encoder Driver Type Changed
  • Prescaler Changed
  • Initial Index
  • Image Transfer Initiated
  • Image Transfer Canceled
  • Image Transfer Cancel Failed
  • Image Verification Initiated
  • Image Verification Successful
  • Image Verification Failed
  • Image Activation Initiated
  • Image Activation Successful
  • Image Activation Failed
  • Count Sample Width Changed
  • Count Sample Rate Changed
  • Legally Relevant Event Log Nearly Full