Itron Cellular 500W

5 – Magnetic detected: The ERT has detected an external magnetic field.

20 – High Flow Detected: The ERT detects that consumption has exceeded the high flow threshold. This event qualifies as an Active Event and will appear in the Active Events buffer until the condition has cleared.

21 – High Flow End: The ERT detects that consumption has dropped below the high flow threshold after having been in a High Flow state. Note: If the device is in a High Flow detected state and high flow detection is disabled, the ERT logs this event immediately.

504 – Flash Data Error: A flash error has been detected.

505 – Meter Quiet Mode Exit: This event occurs when the ERT first receives pulses or when it detects consumption and wakes from Meter Quiet Mode which is a sub-mode of Factory Ship Mode. If the device wakes from Factory Ship Mode (not Meter Quiet Mode), this event is not logged.

506 – Entering Network Mode: The device has been changed to Network mode.

507 – Battery Parameters Set: Any change to the BatteryUseParameters structure results in this event.

509 – Key Update Succeeded: The key has been updated in the device.

511 – Load Profile Cleared: The Load Profile object has been cleared. The following list describes the causes of this event. ► Transitioning from 100S (Run, Factory, Quiet) to IoT mode, or from IoT to 100S mode. ► (IoT mode only) Setting the interval size to a new value. ►Setting count rate, initial index, PCOMP, Rollover, EncoderDrivertype (100S or COSEM) to a new value. ►(IoT mode only) Manual time set (for example, not through network slewing).

512 – Manual Time Sync: The time has been changed manually. This event is also logged the first time the device joins a network (the first time startup followed by the first time it receives network time).

515 – Time Outside Automatic Sync Threshold:The time change is greater than the warning level threshold. This event is the initial detection of the time change exceeding the warning level threshold.

516 – Time Outside Automatic Sync Threshold Ended: The time change is greater than the warning level threshold. This event occurs when the time change is no longer greater than the warning level threshold.

517 – Entering 100S Mode: The device has been changed from Network mode to 100S mode.

531 – EFC State Changed: The EFCState (0.128.96.9.50.255) current_state (attribute 2) control_state, EFC_role, or the device's parent in the neighbor_MAC_address array has changed.

541 – Corrupt Alarm Data Received From Meter: The endpoint has received a corrupt data character in the Alarm Flags field of the encoded frame from the attached meter.The endpoint logs this event as soon as it receives the corrupt data character from the meter. The event in the endpoint is not logged again for the remainder of the current day (day ends at midnight UTC endpoint time). This results in a maximum of one of this event being logged per day.

543 – Fixed Network Connection Check Enable Changed: The FixedNetworkConnectionCheckEnable (OBIS 0.128.96.1.15.255) FNCC_Enable has changed.

3040 – High Flow Threshold Configuration Changed: A change was made to the HighFlowEventConfiguration.